Diy organization ideas for jewelry

For cases when the polishing cloth isnt enough to remove tarnish, you can make your own economically- and environmentally-friendly silver cleaner using ingredients from your kitchen.

It should be noted, however, that silver cleaners are not for every types of silver jewelry. You should not, for instance, ever immerse jewelry adorned with pearls or opaque gemstones (e.g. turquoise, opal, carnelian, onyx), as this could seriously damage these softer stones. (Give these pieces a extremely brief rinse if they become too dirty.)

Even for jewelry with clear gemstones (e.g.

blue topaz, amethyst, garnet), take special care when using a silver cleaner: the chemicals could lodge under the gemstone settings or loosen any glue. And remember, do not use silver cleaners on your oxidized jewelry — stick to the polishing cloth instead.

After using any cleaner, be certain to thoroughly rinse your silver with running water or a clean, damp cloth. This is especially significant for detailed or etched items, since polish can stick in little crevices and harden.

After, dry the pieces with a microfiber cloth to prevent white water spot stains from forming.

Soap and water: Warm water and a mild, ammonia- and phosphate-free dishwashing soap should be your first line of defense if the polishing cloth fails to remove tarnish. Soap and water should also be used to clean your pieces before using any of the methods listed below.

Baking soda and water: You might own heard that a non-whitening, non-gel toothpaste can be a excellent substitute for commercial silver cleaners, but nowadays these basic toothpastes are hard to discover or distinguish from the toothpastes that will discolor your silver. Instead, make a paste of baking soda and water and use a clean cloth to apply a pea-sized quantity to the silver and polish.

For etched, stamped or detailed items, thin the paste with more water and use a clean, soft-bristled toothbrush to get the cracks and crevices. Run the silver piece or pieces under running warm water, and dry with a clean cloth.

Olive oil and lemon juice:Mix 1/2 cup lemon juice with 1 tsp. olive oil in a bowl large enough to hold the cleaning solution and a little microfiber cloth. Dip the cloth in the solution and wring it out so that it doesnt drip, then polish the silver, rinse, and dry.

White vinegar and baking soda: Use this tender cleaner to remove heavy tarnish thats preventing you from polishing your silver.

Soak the tarnished piece in a solution of 1/2 cup white vinegar and 2 tbsp. baking soda (be prepared for the fizzing!) for two to three hours, then rinse and dry.

Baking soda, salt, aluminum foil, and boiling water:You can take advantage of a simple chemical reaction to clean your silver: every youll need is some baking soda, salt, and aluminum foil. Line a glass roasting pan or the kitchen sink with aluminum foil, dull side facing below.

Put the silver pieces on top of the aluminum foil. Then pour boiling water over the pieces until they are covered and add 2 tbsp.

Diy organization ideas for jewelry

each of baking soda and salt. Stir the solution to permit the baking soda to dissolve — you dont desire any granules scratching the metal.

The reaction causes the tarnish to transfer to the foil, and in about minutes youll see the tarnish magically vanish from the jewelry. (Be prepared for the smell of rotten eggs, though, as the sulfide tarnish comes off the silver.) Using salad tongs or nitrile gloves (not rubber gloves, which contain sulfur), remove the silver jewelry from the boiling water or drain into a colander. Rinse the jewelry with water, then dry and buff with a soft cloth.

Diy organization ideas for jewelry

Voila! Your silver should be sparkling clean and ready to hold you looking fabulous.

Combination: If your pieces own extremely stubborn tarnish, you can use these treatments in succession to get them looking shiny again.


Polishing

Simply polishing your silver works well when the tarnishing is not too severe. Its also the best method for cleaningoxidized silver, as you can stay away from the intentionally tarnished areas.

Silver is soft and can become scratched easily. You can use a special silver cloth to polish your items, but a lint-free flannel, microfiber, or other soft nonabrasive cloth will do as well.

Do not use paper towels or tissues to polish your jewelry as they contain fibers that can scratch the silver.

When polishing, use endless back-and-forth motions that mirror the grain of the silver. Do not rub in circles, as this will magnify any tiny scratches. Also, change to a diverse section of your cloth frequently to avoid placing tarnish back on the silver. You can use a Q-tip to get into little, detailed areas.

Be careful with silver-plated items, as excessive polishing can remove the plating (depending on the thickness) and leave pieces worse than when they started.


The drawer method

Paola knew that no matter where she decided to store her jewelry, she still wanted to hold it mostly out of sight.

"I do own some jewelry showcased on a tabletop, but storing every my jewelry that way would make a room glance too cluttered," she explains.

Diy organization ideas for jewelry

"I love a minimalist decor style." A jewelry box or a contraption that hangs from the door are still visually obtrusive. So, Paola thought outside—well, actually, inside—the box. "A dresser drawer felt love an organized, clean way to store everything and still own simple access to it," she says.

1. Pick a drawer, any drawer
To make room for her new jewelry setup, Paola reorganized her dresser, moving the clothes she was keeping in the top drawer to a lower one.

2.

Compartmentalize
Paola turned to Amazon to discover storage compartments she could fit Tetris-style into the drawer. Stock your Home sells a multipack of tray styles that you can stir and match based on your jewelry situation. Because Paola's match the inside of her drawer, from afar you could be fooled into thinking the setup is custom. "It is fairly simple; it looks more complicated than it is. I really just separate my rings, earrings and necklaces into the diverse sections," she says. "My husband Hector occasionally uses it as well, for his cufflinks.

Mostly, I store my favorite pieces that I use often so that I own simple access to them."

If you are anything love me, you forget about most of the jewelry you own and only wear a few pieces.

Diy organization ideas for jewelry

By getting most of my jewelry out of a box and up where I can see it regularly, I am reminded of what I own and can change it up easier.

The main structure for this organizer is beautiful simple; you just need a couple 1×3 boards, a decorative aluminum screen, wood screws and stain.

The screen will be the most expensive part, and price varies depending on pattern and size. The piece I used was leftover from another project, but brand new was $16 for a 24”x36” sheet in a Union Jack pattern.

You will also need picture hanging hardware if you desire to hang it on the wall, S hooks and cup hooks, and if you own one, a staple gun with staples 1/2” or less (this is the easiest way to fasten the screen to the wood, but you can also use screws).

If you are trimming the screen to a diverse size you will also need tin snips.

I made my organizer with two layers of wood, with the screen sandwiched between the two. This picture is of the top layer, consisting of the frame top, sides, shelf*, and bottom. The second (back) layer is mostly the same, except the sides run the full top to bottom and there is no shelf board on the back. **My cut dimensions are below.

This should make more sense in the following pictures.

*I used a scrap 1×4 for the shelf to give me a little more space, but the size is up to you.

**My cut dimensions: (all boards I used were 1×3 [actually 11/16” x 2 3/8”] furring strips EXCEPT for my shelf, which was a scrap 1×4 [11/16” x 3 5/16”].

Please adjust your measurements based on your wood thickness and size variations.**)

-screen: 21”x24”

-front top, bottom and shelf: 23”

-front sides: 20 1/4”

-back top and bottom: 18 1/2”

-back sides: 25 3/4”

FINAL DIMENSIONS: 25 3/4” T x 23” W x 4” D

All the boards were cut, sanded, and stained. I used a stir of Minwax Dark Walnut and Early American.

After everything dried, I arranged the back layer on a flat surface and then stapled the screen onto it. Take your time with this. The boards aren’t attached to each other yet, so carefully line up the screen and put several staples along one board, then go to the board on the opposite side, tug the screen taut and staple.

Diy organization ideas for jewelry

Then do the other two boards. Because the vertical sides were the endless ones on the back layer, I started with those, and then did the top and bottom.

This screen is super thin and bends easily, so you need to make certain it is tight and does not own much wobble.

Next, I put the entire top layer on, lined it up carefully, and clamped the top and sides in place.

Next, I piloted and screwed from the bottom of the shelf into the bottom of the sides.

This way there are no visible screws on the front of the organizer, and it is easier to line up than trying to go through the back into the shelf.

After the shelf is secured, clamp the bottom board in put and flip the whole thing over to screw through the back layer into the front. You will also add your hanging hardware. I used rings, but you can also use saw hangers or hanging wire.

Here is what the layers should glance like.

Time for finishing touches. The S-hooks are used to hang necklaces and can be positioned wherever you need them on the screen.

I added cup hooks to the bottom board and bottom of the shelf, and use them to hang bracelets, watches and rings.

Hang earrings through the screen.

Getting my jewelry out showed me how numerous pieces were tarnished and need to be cleaned.

😬

Here is my final jewelry organizer! I still hold my nicer jewelry in a box, but now my “everyday” jewelry is out where I can see it.

Some variation ideas:

-Spray paint the screen and hooks in any color you desire. The frame could also be painted instead of stained.

-Lean it against a wall or make a back support (like a picture frame) if you live in an apartment or don’t desire to add holes in the wall to hang. (This would work best with a smaller version or one without the shelf so it doesn’t own as much weight.)

-If building a frame is too much for you, purchase a pre-made wood frame, remove the glass and back, and glue/staple the screen into it.

I’d love to see pictures of your version!

Its hard not to be crazy about sterling silver jewelry.

Between its luster, its brilliance, and its versatility, its simple to see why silver is one of the most favorite materials for jewelry.

Still, numerous of us discover ourselves neglecting every the beautiful silver pieces in our jewelry boxes for one simple, annoying reason: tarnish. When oxygen or sulfur come in contact with silver, they chemically bond to its surface and cause the silver to appear dirty or discolored.

Who wants that?

Fortunately, caring for silver and reducing tarnish is as simple as doing the dishes. Every you need is to arm yourself with a few facts about the metal and a few tips and tricks for care and cleaning. With this ultimate guide, youll leave ready to start wearing your fabulous silver again with every its shine!


A few things about sterling silver

Knowing a few industry terms will assist you understand the physical attributes of your jewelry and how to care for it. The purity of the metal, for instance, determines how malleable the silver is and how quickly it will tarnish:   sterling silver will bend more easily and tarnish more quickly than sterling silver because of its increased purity, so additional caution should be used to take care of silver jewelry.

Oxidized is another term used to describe silver.

For some works silversmiths intentionally permit parts of the jewelry to darken and oxidize, typically little details, to make them stand out more. This detailing can be lost, though, with excessive cleaning and polishing.

Diy organization ideas for jewelry

So be certain to identify any purposefully oxidized silver bracelets, earrings, rings or necklaces you own and set them aside for separate cleaning.

Sterling silver dangle earrings, Denpasar Mystique


Professional care

If your pieces are heavily tarnished and you dont own the time to clean them, take them to a professional silver cleaner. Extremely ancient, fragile, or valuable pieces should also be cleaned by a professional.


Preventative care

Wear: You can avoid tarnish by wearing your jewelry often. The oils in your skin will clean the silver and hold it looking shiny.

Avoid exposure: Contact with household chemicals, perspiration, rubber, chlorinated water, or any substances which contain sulfur (e.g., mayonnaise, eggs, mustard, onions, latex, wool), will cause corrosion and tarnish — so its a excellent thought to remove silver jewelry when doing household chores.

Direct sunlight also causes silver to tarnish, so be certain to take off your silver jewelry before you go swimming and sunbathing.

Lotions, cosmetics, hair spray and hair products, and perfumes are also enemies of silver and will accelerate tarnishing. Theres a reason generations of women own been getting dressed with jewelry final, as a finishing touch!

Storage: As exposure to air tarnishes it, storing silver in airtight plastic bags with anti-tarnish strips is a grand preventative measure.

Just make certain you dont store multiple jewelry pieces in the same bag: silver is a soft metal, so the individual pieces can scratch each other. Link or chain bracelets should be kept unclasped or unhooked to prevent scratching as well. If you cant use plastic bags, attempt to make certain that the storage area has low humidity. You can also put a piece of chalk, a packet of activated charcoal, or a container of silica gel in the storage area to minimize tarnish.


What about commercial silver cleaners?

Commercial silver polishes and dips are simple to discover and use, but own several serious drawbacks.

For one, the vapors from silver polish can cause damage and even be fatal if inhaled in an unventilated room. The powerful solvents in commercial silver cleaners may also require special hazardous waste disposal to avoid contaminating groundwater or causing other environmental harm.

As if these health and environmental concerns werent enough, commercial silver cleaners can also actually harm your silver by removing the anti-tarnish coating and valuable patina. Even though cleaners might give a temporary shine, the pieces will tarnish much more quickly and own to be cleaned more frequently once you own broken below the surface.


RELATED VIDEO: